Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
Important: The end cap should be installed on the end of the wiper blade that will be the farthest from the wiper motor drive shaft.
- Install the end cap on the wiper blade.
Important: The element must be secure in all the claw sets.
- Install the new element into the wiper blade and the end cap until the inner claw set engages the vertebra notches.
- Install the wiper blade onto the wiper arm. Refer to Wiper Arm Blade Replacement - Rear .