LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 793 (Lighting Systems) >> Repair Instructions >> Fog Lamp Aiming Procedure >> Preparation Procedure

Preparation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Horizontal aim is not adjustable on this vehicle. Vertical aim is done by an adjusting nut located on the rear of the fog lamp. Prior to aiming the fog lamps, perform the following steps:

  1. Completely assemble all of the components on the vehicle.
  2. Place the vehicle on a level surface.
  3. Stop all unnecessary operations or work that could affect the ride height of the vehicle.
  4. Close the doors and verify that the luggage compartment is empty.
  5. Stabilize the suspension by rocking the vehicle sideways.
  6. Ensure that the fuel level is full.
  7. Ensure that the tires are inflated to the proper pressure.
  8. Ensure that the driver or a similar weight, approximately 74.82 kg (165 lbs) is in the vehicle driver seat.
    Fig 1: Fog Lamp Aiming Procedure
    G01812998Courtesy of GENERAL MOTORS CORP.