Conditions For Running DTC

DTCs P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0121, P0122, P0123, P0131, P0132, P0133, P0134, P0135, P0137, P0138, P0140, P0141, P0151, P0152, P0153, P0154, P0155, P0157, P0158, P0161, P0200, P0300, P0335, P0336, P0351, P0352, P0353, P0354, P0355, P0356, P0357, P0358, P0506, P0507, P1133, P1134, P1138, and P1171 are not set.

Passive Tests

• The engine is running.
• The engine speed is more than 600 RPM.
• The throttle is steady.
• The engine load is less than 80 percent.
• The system voltage is more than 10.5 volts.
• The Mass Air Flow (MAF) is less than 35 g/s.
• The air/fuel ratio is more than 12.5:1.
• The Engine Coolant Temperature (ECT) is between 41-230°F (5-110°C).
• The Intake Air Temperature (IAT) is between 41-140°F (5-60°C).
• The power enrichment or the Deceleration Fuel Cut-Off (DFCO) is not active.

Active Tests

• The engine is running.
• The engine speed is more than 600 RPM.
• The throttle is steady.
• The engine load is less than 80 percent.
• The system voltage is more than 10.5 volts.
• The MAF is less than 35 g/s.
• The fuel system is in Closed Loop operation.
• The Evaporative (EVAP) emissions purge is active.
• The ECT is more than 154°F (68°C).