LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 789 (Engine Mechanical (On-Vehicle)) >> Repair Instructions >> Crankshaft Rear Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the engine flywheel. Refer to Engine Flywheel Replacement .

    Important:  Do not damage the crankshaft or seal bore.

    2. Fig 1: Removing Crankshaft Rear Oil Seal
    G01828801Courtesy of GENERAL MOTORS CORP.
  2. Remove the crankshaft rear oil seal.

    Pry the crankshaft rear oil seal out using a suitable tool.

scientia non olet · About LEMON Manuals