LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 786 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Knee Bolster Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the IP insulator. Refer to one of the following procedures:
  2. Remove the bolts/screws from the bottom of the knee bolster.
  3. Pull on the knee bolster in order to release the upper clips.
    Fig 1: Removing Bolts/Screws From Bottom Of Knee Bolster
    G01813391Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals