Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the ignition lock cylinder through the upper shroud.
- Align the lock cylinder retaining tab and the position tab with the slots in the lock housing.
- Push the lock cylinder into the lock housing completely.
- Install the LOWER trim cover. Refer to STEERING COLUMN TRIM COVERS REPLACEMENT - On Vehicle .
- Install the tilt wheel lever.
- Install the steering wheel. Refer to Steering Wheel Replacement .
- Install the inflator module. Refer to REMOVAL & INSTALLATION (DRIVER-SIDE) .
- Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
- Connect the battery negative cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE .