LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 782 (Steering Wheel & Steering Column) >> Repair Instructions >> Automatic Transmission Shift Lock Control - Assemble - Off Vehicle

Automatic Transmission Shift Lock Control - Assemble - Off Vehicle

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the automatic transmission shift lock control to the steering column jacket assembly.
    Fig 1: Automatic Transmission Shift Lock Control
    G01827128Courtesy of GENERAL MOTORS CORP.
  2. Adjust the automatic transmission shift lock control.
    1. Install the shift lever if not present.
    2. Pull the tab (1) out on the block (2) side of the automatic transmission shift lock control.
    3. Shift the column into the NEUTRAL position.
      4. Fig 2: Adjuster Block
      G01827129Courtesy of GENERAL MOTORS CORP.
    4. Press on the adjuster block (2) to compress the internal adjuster spring to disengage the adjuster teeth. Slide the adjuster block (2) as far away from the solenoid as possible.
    5. Shift the column into NEUTRAL.
    6. Lock in place by pushing the tab (1) back in.
  3. Inspect the automatic transmission shift lock control.
    1. The automatic transmission shift lock control must lock the gear shift lever when it is put into the PARK position.
    2. When the column is installed in the vehicle you will not be able to shift the gear shift lever out of the PARK position without pressing on the brake pedal. The solenoid will be energized.
    3. Readjust if needed.
  4. Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals