Compressor Control Switches Removal (V5 - Conventional Mount)

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 5403 Snap Ring Pliers
J 9553-01 O-Ring Remover
J 39500-B ACR4-Black Shroud

Recover the refrigerant using the J 39500-B .
Disconnect the electrical connector from the switch (3 or 4) in the rear head of the compressor.
Remove the switch retaining ring using the J 5403 .
Remove the switch (3 or 4) from the compressor.

Fig 1: Compressor Control Switches
Courtesy of GENERAL MOTORS CORP.

NOTE: If the existing switch will be reinstalled in the compressor, a new O- ring seal must be used and preferably a new retainer should also be used. A new switch kit has the O-ring and retainer ring included.
Remove the old O-ring seal from the switch cavity using the J 9553-01 .