Compressor Clutch Plate and Hub Assembly Removal (V5 - Conventional Mount)

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 33022 6-Point 13 mm Socket
J 33027-A Clutch Hub Holding Tool
J 33013-B Hub And Drive Plate Remover/Installer
J 34992 Compressor Holding Fixture

Clamp the J 34992 in a vise.
Attach the A/C compressor to the holding fixture using the thumb screws.
Use the J 33027-A in order to prevent the clutch hub and drive plate assembly from turning.
Use the J 33022 in order to remove the shaft nut.

Fig 1: Remove Shaft Nut Using J 34992, J 33022 & J 33027-A
Courtesy of GENERAL MOTORS CORP.
Thread the J 33013-B into the hub.
Use a wrench in order to hold the body of the J 33013-B .
Turn the center screw into the body of the J 33013-B in order to remove the clutch plate and hub assembly.
Remove the shaft key. Retain the shaft key for reassembly.

Fig 2: Clutch Plate, Hub Assembly, J 33013-B & J 34992
Courtesy of GENERAL MOTORS CORP.