Compressor Clutch Coil Install (V5 - Direct Mount)

Tools Required 

• J 33024  Clutch Coil Installer Adapter
• J 33025  Clutch Coil Puller Legs
• J 8433  Compressor Pulley Puller
• J 8433-3  Forcing Screw
• J 41790  Compressor Holding Fixture
• J 42136  A/C Lip Seal Remover

1. Place the clutch coil assembly (1) on the front head with the clutch coil terminal at the positioned at the mark made during disassembly.
2. Place the J 33024  over the internal opening of the clutch coil housing and align installer with the compressor front head.
3. Install the J 8433-3  into the J 8433  and center the screw in the countersunk center hole of the J 33024  .
   Fig 1: Clutch Coil Assembly & Special Tools

   Courtesy of GENERAL MOTORS CORP.
4. Install the 4 inch through bolts and washers from the J 42136  tool kit into the J 33025  and attach them to the compressor mounting bosses.
5. Turn the center forcing screw of the J 8433  to press the clutch coil onto the front head until the clutch coil is fully seated.

   Make sure the clutch coil and the J 33024  stay in-line with each other while pressing the clutch coil onto the compressor.

6. Install the compressor clutch rotor and bearing assembly. Refer to Clutch Rotor and/or Bearing Install (V5 - Direct Mount)  or Clutch Rotor and/or Bearing Install (V5 - Conventional Mount) .
7. Install the compressor clutch plate and hub assembly. Refer to Compressor Clutch Plate/Hub Assembly Install (V5 - Direct Mount)  or Compressor Clutch Plate/Hub Assembly Install (V5 - Conventional Mount) .
8. Remove the compressor from the J 41790  .