LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 781 (Heating, Ventilation & Air Conditioning) >> Repair Instructions >> Blower Motor Resistor Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right side instrument panel insulator.

    Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT -- RIGHT .

  2. Disconnect the electrical connectors from the blower motor resistor.
    Fig 1: Electrical Connector
    G01672742Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the blower motor resistor electrical connector from the blower motor.
    Fig 2: Blower Motor Resistor Electrical Connector
    G01672743Courtesy of GENERAL MOTORS CORP.
  4. Loosen, but do NOT remove, the forward screws.

    Important:  The blower motor resistor opening is slotted as access is extremely limited.

  5. Remove the rearward screw.
  6. Remove the blower motor resistor.
    Fig 3: Blower Motor Resistor & Rearward Screw
    G01672744Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals