LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 781 (Heating, Ventilation & Air Conditioning) >> Repair Instructions >> Air Temperature Door Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the HVAC module. Refer to HVAC Module Assembly Replacement .
  2. Remove the screws retaining the left air temperature actuator.
  3. Remove the left air temperature actuator.
  4. Remove the air inlet housing retaining screws (1).
  5. Remove the air inlet housing (2).
    Fig 1: Air Inlet Housing & Retaining Screws
    G01672786Courtesy of GENERAL MOTORS CORP.
  6. Remove the HVAC module upper mounting screws.
  7. Release the retaining tab (1) and separate the upper and lower module halves.
    Fig 2: Upper & Lower Modules & Retaining Tab
    G01672787Courtesy of GENERAL MOTORS CORP.
  8. Remove the HVAC module seal that is located between the upper and lower cases.

    Start to remove the module case seal (blower motor side of case) seal (2) from the lower module case at the position shown (1).

    Fig 3: Starting Position For Module Case Seal Removal
    G01672788Courtesy of GENERAL MOTORS CORP.
  9. Remove the left air temperature actuator.
    Fig 4: Left Air Temperature Actuator
    G01672789Courtesy of GENERAL MOTORS CORP.

    Important:  The left and right air temperature actuators separate in the center.

  10. Remove the left air temperature actuators (1, 2). Carefully pull the air temperature actuators apart in the center to remove the air temperature actuators from the HVAC module case.
    Fig 5: Left & Right Air Temperature Actuators
    G01672790Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals