LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 779 (Automatic Transaxle Service, Removal & Installation -- 4T65-E) >> Repair Instructions >> Torque Converter Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the torque converter cover.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the torque converter cover bolts.

    Tighten 

    Tighten the bolts to 10 N.m (89 lb in).

  3. Lower the vehicle.
    Fig 1: Installing Torque Converter Cover Bolts And Cover
    G01531498Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals