LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 779 (Automatic Transaxle Service, Removal & Installation -- 4T65-E) >> Repair Instructions >> Output Shaft Replacement (M15) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the drive axle retaining ring (509) and the output shaft differential inboard snap ring (512) onto the output shaft (510).
  2. Install the fourth clutch bearing (511) onto the output shaft (510).
  3. Hold the front differential carrier (700) in place and carefully install the output shaft (510) into the transmission through the left wheel opening. Extend the output shaft through the differential side gear.
  4. Install the case extension housing. Refer to CASE EXTENSION HOUSING REPLACEMENT  .
  5. Connect the left drive axle to the transaxle. Refer to AXLE SHAFT in Wheel Drive Shafts.
    Fig 1: Installing Drive Axle Retaining Ring And Output Shaft Differential Inboard Snap Ring Onto Output Shaft
    G01531471Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals