LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 779 (Automatic Transaxle Service, Removal & Installation -- 4T65-E) >> Repair Instructions >> Oil Pressure Test Plug Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the throttle body air inlet duct. Refer to ENGINE CONTROLS - REMOVAL & INSTALLATION & OVERHAUL in Removal and Installation in Engine Performance.
  2. Remove the pressure test hole plug (38).
    Fig 1: Removing Pressure Test Hole Plug
    G01531388Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals