LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 779 (Automatic Transaxle Service, Removal & Installation -- 4T65-E) >> Repair Instructions >> Front Wheel Drive Shaft Oil Seal Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to JACKING AND LIFTING in General Information.
  2. Remove the right front tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION  in Tires and Wheels.
  3. Remove the right engine splash shield. Refer to SPLASH SHIELD REPLACEMENT - ENGINE in Body Front End.
  4. Remove the right stabilizer shaft brackets from the right lower control arm. Refer to STABILIZER SHAFT LINK REPLACEMENT in Front Suspension.
  5. Remove the right tie rod end from the right steering knuckle. Refer to TIE ROD END REPLACEMENT - OUTER  in Power Steering System.
  6. Remove the right lower ball joint from the lower control arm. Refer to LOWER BALL JOINT REPLACEMENT .
  7. Remove the right wheel drive shaft from the transaxle. Refer to AXLE SHAFT in Wheel Drive Shafts.
  8. Secure the right wheel drive shaft to the right steering knuckle and strut.
  9. Using the J 6125-B  with the J 6125-1B  and the J 23129  remove the wheel drive shaft oil seal (1) from the transmission.
    Fig 1: Removing Wheel Drive Shaft Oil Seal (Right)
    G01531386Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals