LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 779 (Automatic Transaxle Service, Removal & Installation -- 4T65-E) >> Repair Instructions >> Automatic Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transaxle mount to the transaxle mount frame bracket.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the transaxle mount lower nuts to the transaxle mount frame bracket.

    Tighten 

    Tighten the nuts to 47 N.m (35 lb ft).

  3. Install the transaxle mount bracket to the transaxle. Refer to AUTOMATIC TRANSMISSION MOUNT BRACKET REPLACEMENT   . 
    Fig 1: Installing Transaxle Mount Lower Nuts And Transaxle Mount
    G01531490Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals