LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 778 (Engine Mechanical - 3.1L Unit Repair) >> Repair Instructions >> Oil Cooler Installation

Oil Cooler Installation

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE .
  1. Install the oil cooler hose fitting.

    Tighten 

    Tighten the oil cooler hose fitting to 19 N.m (14 lb ft).

    Fig 1: Oil Cooler Hose Fitting
    G01703027Courtesy of GENERAL MOTORS CORP.
  2. Install the oil cooler inlet hose clamp and the oil cooler inlet hose onto the oil cooler hose fitting.
    Fig 2: Oil Cooler Inlet Hose
    G01703028Courtesy of GENERAL MOTORS CORP.
  3. Install the oil cooler inlet hose clamp and oil cooler.
    Fig 3: Oil Cooler
    G01703029Courtesy of GENERAL MOTORS CORP.
  4. Install the oil cooler connector.

    Tighten 

    Tighten the oil cooler connector to 50 N.m (37 lb ft).

    Fig 4: Oil Cooler Connector
    G01703030Courtesy of GENERAL MOTORS CORP.
  5. Install the oil cooler outlet hoses and pipe.
  6. Connect the lower oil cooler outlet hose to the oil cooler.
  7. Connect the upper oil cooler hose to the thermostat bypass pipe.
    Fig 5: Oil Cooler Outlet Hoses
    G01703031Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals