LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 777 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Rear (C Pillar) >> Tools Required >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cover from the upper seat belt (1) anchor.
  2. Use the J 29843-9  in order to remove the upper seat belt anchor bolt (2).

    Important:  The lower seat belt anchor (4) attaches to the mini-buckle on the right side of the 60 percent seat cushion on vehicles equipped with a 60/40 split bench seat. Use a key or a small flat bladed tool in order to release the seat belt anchor from the mini-buckle.

  3. Lift the trim cover in order to expose the lower seat belt anchor bolt (5).
  4. Use the J 29843-9  in order to remove the bolt (5) securing the lower seat belt anchor (4) from the C-pillar.
  5. Remove the cup holder/armrest trim cover (3) from the passenger's side.
  6. Remove the left body side front trim panel. Refer to INTERIOR TRIM  in Interior Trim.
    Fig 1: Removing Cover From Upper Seat Belt Anchor
    G01533744Courtesy of GENERAL MOTORS CORP.
  7. Use the J 29843-9  in order to remove the bolt securing the seat belt retractor from the C-pillar.
  8. Remove the seat side belt retractor from the C-pillar.
    Fig 2: Removing Seat Side Belt Retractor From C-Pillar
    G01533745Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals