LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 775 (Body Rear End) >> Repair Instructions >> Latch Striker Replacement - Lift Gate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align spacer and liftgate striker to holes in body.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the liftgate striker retaining bolts.

    Tighten 

    Tighten the bolts to 25 N.m (18 lb ft).

  3. Close the liftgate.
    Fig 1: Installing Liftgate Latch Striker To Vehicle
    G01533422Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals