LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 774 (Interior Trim) >> Repair Instructions >> Sunshade Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

Important:  If a new sunshade is being installed, align the sunshade in the same position as the old sunshade. If the sunshade is aligned incorrectly, the sunshade will not be properly retained.

  1. Install the sunshade to the roof.
  2. Connect the electrical connector to the sunshade, if equipped with a vanity mirror.
  3. Push upwards in order to engage the sunshade to the roof.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the screw to the sunshade mounting plate.

    Tighten 

    Tighten the screw to 2 N.m (18 lb in).

    Fig 1: Installing Sunshade To Roof
    G01533344Courtesy of GENERAL MOTORS CORP.