LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 773 (Seat System) >> Repair Instructions >> Seat Trim Replacement - Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the finish covers to the seat frame.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the finish cover screws.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  3. Install the cup holder, if equipped. Refer to CUPHOLDER REPLACEMENT - REAR SEAT   .
scientia non olet · About LEMON Manuals