LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 773 (Seat System) >> Repair Instructions >> Seat Switch Replacement - Power >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the adjuster switch electrical connector.
  2. Install the adjuster switch to the finish cover.
  3. Install the finish cover to the seat adjuster.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the finish cover screws.

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  5. Connect the front seat pretensioner electrical connector.
  6. Connect the front seat SIR module electrical connector.
    Fig 1: Installing Adjuster Switch To Finish Cover
    G01531951Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals