LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 773 (Seat System) >> Repair Instructions >> Cupholder Replacement - Rear Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cup holder.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the cup holder screws.

    Tighten 

    Tighten the screws to 9 N.m (80 lb in).

  3. Fold the cup holder to its closed position.
    Fig 1: Installing Rear Seat Cupholder
    G01532093Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals