Diagnostic Mode 2
Enter the diagnostic mode 2 from mode 1 by proceeding with the following steps:
- Press and hold the power sliding door open/close switch for 4 seconds.
- Release the open/close switch when the alarm begins to sound.
- The alarm will sound 2 long tones indicating diagnostic mode 2 is active.
During diagnostic mode 2 the sliding door alarm is used to indicate when the following inputs to the rear side door actuator control module are activated:
The Power Sliding Door On/Off Switch: Turn the on/off switch off and on. The alarm will sound one short tone when the switch is turned from the off to on position.
The Power Sliding Door Open/Close Switch in the Overhead Console: Press the power sliding door open/close switch in the overhead console. The alarm will sound for as long as the switch is held in the open position.
The Power Sliding Door B-pillar Open/Close Switch: Press the power sliding door B-pillar open/close switch. The alarm will sound for as long as the switch is held in the open position.
The Keyless Entry System Open/Close Command: Press the open/close button on the keyless entry transmitter. The alarm will sound one short tone whenever an open or close command is received from the keyless entry system.
The Sliding Door Detent Switch: Turn the on/off switch off and slowly open and close the sliding door. The alarm will sound whenever the detent switch signal circuit is pulled to ground, indicated by 2 tones as the door is moved between the open and fully latched positions.
The Ignition Switch On Signal: Turn the ignition switch on. The alarm will sound for as long as the ignition switch is in the on position.
The Transaxle Range Switch Park Position: Apply the brakes and move the transmission selector lever out of the park position. The alarm will sound for as long as the transaxle is out of park.