LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 769 (Bumper System) >> Repair Instructions >> Splash Shield Replacement - Rear Bumper Fascia >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the rear bumper fascia splash shield to the rear bumper fascia.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the rear bumper fascia splash shield screws to the rear bumper fascia splash shield.
  3. Tighten  Tighten the rear bumper fascia splash shield screws to 2 N.m (19 lb in).
  4. Install the push-in the retainer to the lower rear bumper fascia splash shield.
    Fig 1: Aligning Rear Bumper Fascia Splash Shield To Rear Bumper Fascia
    G01533212Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals