LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 769 (Bumper System) >> Repair Instructions >> Fascia Reflector Replacement - Rear Bumper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Warm the rear bumper fascia with a heat lamp or heat gun to a minimum of 21°C (70°F).

    Important:  DO NOT touch the adhesive backing.

  2. Peel the backing from the front end of the rear bumper fascia reflectors.
  3. Press the rear bumper fascia reflectors to the rear fascia while continuing to remove the backing.
  4. Hand roll the rear bumper fascia reflectors to the rear fascia in order to ensure proper adhesion.
    Fig 1: Peeling Backing From Front End Of Rear Bumper Fascia Reflectors
    G01533210Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals