LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 763 (Instrument Panel, Gages, And Console) >> Repair Instruction >> Lock Cylinder Replacement - Instrument Panel (I/P) Compartment >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the IP compartment latch fork bolt in the up position.
  2. Grasp the IP compartment lock cylinder. Depress the rear-most, light-colored tumbler that is flush with the IP compartment lock cylinder surface.
  3. Insert the key. All tumblers will now stay depressed.
  4. Insert the IP compartment lock cylinder, with the key inserted, into the IP compartment latch housing. Ensure that the front projection pin is at the appropriate 8 o'clock position. The IP compartment lock cylinder will drop into place.
  5. Rotate the key counterclockwise until the key stops.
  6. Remove the key.

    The IP compartment lock cylinder is now locked into the IP compartment latch housing.

  7. Install the IP compartment latch. Refer to LATCH REPLACEMENT - INSTRUMENT PANEL (I/P) COMPARTMENT   . 
    Fig 1: Installing Instrument Panel Compartment Lock Cylinder
    G01534519Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals