LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 759 (Wiper System And Washer System) >> Repair Instructions >> Wiper Arm Blade Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert the hook of the wiper arm through the opening in the wiper blade.
    Fig 1: Inserting Hook Of Wiper Arm Through Opening In Wiper Blade
    G01534216Courtesy of GENERAL MOTORS CORP.
  2. Position the wiper blade pivot in the inside radius of the wiper arm hook.
  3. Pull the wiper blade pivot into the wiper arm hook until the pivot locks into the hook.
  4. Operate the wipers and check for proper operation.
    Fig 2: Pulling Wiper Blade Pivot Into Wiper Arm Hook
    G01534217Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals