LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 759 (Wiper System And Washer System) >> Repair Instructions >> Blade Element Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

Important:  The end cap should be installed on the end of the wiper blade that will be the farthest from the wiper motor drive shaft.

  1. Install the end cap on the wiper blade.

    Important:  The element must be secure in all the claw sets.

  2. Install the new element into the wiper blade and the end cap until the inner claw set engages the vertebra notches.
  3. Install the wiper blade onto the wiper arm. Refer to WIPER ARM BLADE REPLACEMENT - REAR   .
    Fig 1: Installing New Element Into Wiper Blade And End Cap
    G01534220Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals