LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 758 (Lighting Systems) >> Repair Instructions >> High Mounted Stop Lamp Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

Important:  The high-mounted stop lamp has a LED circuit board which is not serviced as a separate part. The entire high-mounted stoplamp must be replaced if the LED circuit board fails.

  1. Remove the screws from the high-mounted stop lamp.
  2. Remove the high-mounted stoplamp from the body.
  3. Disconnect the electrical connector.
    Fig 1: Removing High-Mounted Stoplamp From Body
    G01534109Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals