LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 756 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> General Electrical Diagnosis Procedures >> Using Connector Test Adapters

Using Connector Test Adapters

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Do not insert test equipment probes into any connector or fuse block terminal. The diameter of the test probes will deform most terminals. A deformed terminal can cause a poor connection, which can result in system failures. Always use the J 35616,-A Connector Test Adapter Kit or the J 42675 Flat. Wire Probe Adapter Kit in order to front probe terminals. Do not use paper clips or other substitutes as they can damage terminals and cause incorrect measurements.
scientia non olet · About LEMON Manuals