Circuit Description

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

P0480 is for the low speed cooling fan relay control circuit.
P0481 is for the high speed cooling fan relay control circuit.

Battery positive voltage is supplied to the Cool Fan 1 relay from the COOL FAN 1 fuse. The powertrain control module (PCM) controls the Cool Fan 1 relay By grounding the low speed cooling fan relay control circuit via an internal solid state device called a driver.

Battery positive voltage is supplied to the Cool Fan 2 relay from the COOL FAN 2 fuse. The powertrain control module (PCM controls the relay By grounding the high speed cooling fan relay control circuit.

When the PCM is commanding a relay on, the voltage potential of the control circuit should Be low, near 0 volts. When the PCM is commanding the control circuit to a relay, the voltage potential of the circuit should Be high, near Battery voltage. If the fault detection circuit senses a voltage other than what is expected, the DTC will set.

The PCM will monitor the control circuit for the following:

A short to ground
A short to voltage
An open circuit
An open relay coil
An internally shorted or excessively low resistance relay coil

When the PCM detects any of the above conditions, the DTC will set and the affected driver will Be disabled.