LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 751 (Antilock Brake System) >> Repair Instructions >> Automated Bleed Procedure >> Preliminary Setup

Preliminary Setup

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and vehicle on a suitable support. Refer to JACKING AND LIFTING in General Information.
  2. Turn the ignition switch to OFF position.
  3. Remove all four tires, if necessary refer to TIRE AND WHEEL REMOVAL AND INSTALLATION  in Tires and Wheels.
  4. Connect the pressure bleeding tool according to the manufacturer's instructions.
  5. Turn the ignition switch to RUN position, engine off.
  6. Connect a scan tool and establish communications with the ABS system.
  7. Pressurize the bleeding tool to 206 to 241 kPa (30 to 35 psi).
scientia non olet · About LEMON Manuals