LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 750 (Transfer Case - STEYR) >> Repair Instructions >> Axle Shaft Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to JACKING AND LIFTING in General Information.
  2. Remove the right front tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION  in Tires and Wheels.
  3. Remove the right front wheel drive shaft. Refer to AXLE SHAFT  in Wheel Drive Shafts.
  4. Using the J 2619-01  with the J 29794  and the J 23129  remove the axle shaft oil seal (1) from the transfer case.
    Fig 1: Removing Axle Shaft Oil Seal From Transfer Case
    G01485208Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals