Rear Leveling Shock Absorbers
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
The shock absorber is essentially a conventional shock absorber enclosed in an air chamber. The shock absorbers are constructed with a rubber-like sleeve attached to the dust tube and attached to the shock reservoir. This makes a flexible chamber which extends the shock when the air pressure in the chamber is increased. The weight of the vehicle collapses the shock absorber when the air pressure is reduced. To maintain proper operation and to maintain reliability to the shock absorber a minimum residual air pressure of 55 kPa (8 psi) is maintained at all times by the air dryer.