Inspection Procedure
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle with safety stands. Refer to JACKING AND LIFTING
in General Information.CAUTION: Wear gloves when inspecting the tires in order to prevent personal injury from steel Belts sticking through the tire.
- Perform the following preliminary inspection:
- 2.1 Mark the tire with a crayon in order to note the start and the stop position.
- 2.2 Rotate each tire and wheel By hand.
- 2.3 Inspect the tire for Bulges or Bent wheels. Replace as necessary.
- Use tire substitution in order to identify the faulty tire. Perform the following steps for a tire substitution check:
- 3.1 Use a comparable tire in order to replace each tire, one at a time.
- 3.2 Test drive the vehicle.
- 3.3 If the problem is tire or wheel related, you will eliminate the problem when you remove the faulty tire from the vehicle.