A/C Refrigerant Pressure Sensor

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

The A/C refrigerant pressure sensor is a 3-wire piezoelectric pressure transducer. A 5-volt reference, low reference, and signal circuits enable the sensor to operate. The A/C pressure signal can be between 0-5 volts. When the A/C refrigerant pressure is low, the signal value is near 0 volts. When the A/C refrigerant pressure is high, the signal value is near 5 volts.

The A/C refrigerant pressure sensor protects the A/C system from operating when an excessively high or low pressure condition exists. The PCM disables the compressor clutch under the following conditions:

A/C pressure is more than 2979 kPa (432 psi). The clutch will be enabled after the pressure decreases, to less than 1620 kPa (235 psi).
A/C pressure is less than 179 kPa (26 psi). The clutch will be enabled after the pressure increases to more than 207 kPa (30 psi).

The purpose of the heating and A/C system is to provide heated and cooled air to the interior of the vehicle. The A/C system will also remove humidity from the interior and reduce windshield fogging. The vehicle operator can determine the passenger compartment temperature by adjusting the air temperature switch. Regardless of the temperature setting, the following can effect the rate that the HVAC system can achieve the desired temperature:

Recirculation actuator setting
Difference between inside and desired temperature
Difference between ambient and desired temperature
Blower motor speed setting
Mode setting
Auxiliary HVAC settings