LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 741 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement - Auxiliary (with E59) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left lower quarter trim panel.
  2. Disconnect the auxiliary blower motor electrical connector.
  3. Disconnect the auxiliary blower motor resistor electrical connector.
  4. Remove the lower auxiliary air distribution duct bolts and retainers.
    Fig 1: Removing Lower Auxiliary Air Distribution Duct, Bolts & Retainers
    G01482686Courtesy of GENERAL MOTORS CORP.
  5. Remove the lower auxiliary air distribution duct.

    Important:  The auxiliary blower motor must be removed with the blower motor housing.

  6. Remove the auxiliary blower motor housing screws.
  7. Lift the auxiliary blower motor housing and remove from the HVAC module assembly.
    Fig 2: Removing HVAC Module Assembly From Auxiliary Blower Motor Housing
    G01482687Courtesy of GENERAL MOTORS CORP.
  8. Remove the auxiliary blower motor mounting screws.
  9. Remove the auxiliary blower motor from the blower motor housing.
    Fig 3: Removing Auxiliary Blower Motor From Blower Motor Housing
    G01482688Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals