LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 734 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Left Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the seat belt guide loop cover.
  2. Remove the seat belt guide loop nut.
    Fig 1: Removing Seat Belt Guide Loop Nut
    G01504727Courtesy of GENERAL MOTORS CORP.
  3. Remove the seat belt guide loop from the guide adjuster bracket.
  4. Remove the upper center pillar panel trim. Refer to TRIM PANEL REPLACEMENT - UPPER CENTER PILLAR in Interior Trim.
  5. Remove the lower center pillar panel trim. Refer to TRIM PANEL REPLACEMENT - LOWER CENTER PILLAR in Interior Trim.
  6. Remove the intermediate guide bolts.
    Fig 2: Removing Intermediate Guide Bolts
    G01504728Courtesy of GENERAL MOTORS CORP.
  7. Remove the anchor plate nut from the seat stud.
    Fig 3: Removing Anchor Plate Nut From Seat Stud
    G01504729Courtesy of GENERAL MOTORS CORP.
  8. Remove the anchor plate from the seat stud.
  9. Remove the retractor side belt bolt.
  10. Remove the retractor side belt from the lower center pillar.
    Fig 4: Removing Retractor Side Belt Bolt
    G01504730Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals