LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 731 (Seat System) >> Repair Instructions >> Seat Adjuster Replacement - Front (Six-Way Power) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat from the vehicle. Refer to SEAT REPLACEMENT - FRONT BUCKET  .
  2. Remove the seat belt buckle nut.

    Remove the seat belt from the seat.

  3. Remove the J-hooks holding the seat trim cover to the seat frame.
  4. Remove the front seat trim panel. Refer to TRIM PANEL REPLACEMENT - FRONT SEAT  .
    Fig 1: Removing Seat Belt From Seat
    G01504391Courtesy of GENERAL MOTORS CORP.
  5. Position the seat back all the way down.
  6. Lift up on the cushion trim cover and pad to access the seat frame to adjuster bolts.
  7. Remove the seat frame to adjuster bolts.
  8. Disconnect the electrical harness from the adjuster cross brace.
  9. Disconnect the seat belt electrical harness, drivers seat only.
  10. Disconnect the electrical harness from the 3 electric motors.
  11. Remove the lumbar adjuster relays from the motor bracket.
  12. Remove the adjuster from the seat cushion frame.
    Fig 2: Removing Adjuster From Seat Cushion Frame
    G01504392Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals