Test Description

The numbers below refer to the step numbers in the diagnostic procedures.

1. 2
   
   Wetting down the secondary ignition system with water from a spray bottle may help locate damaged or deteriorated components. Look and listen for arcing or misfiring as you apply the water.

   If the Misfire Current counters are incrementing and there is no apparent misfire, an erratic CKP sensor signal could be the cause. Perform the diagnostic test for DTC P0335 first if this condition is suspected.

   If a misfire is present and you suspect a fuel control problem, force the fuel system into Open Loop using the scan tool and allow the engine to run for a few minutes. If this eliminates the misfire, refer to any fuel control related DTCs which are set. If no other DTCs are set, refer to the Engine Scan Tool Data List.

   The Misfire Current Counters will not increment if certain DTCs set at the same time or after DTC P0300 sets.

   If more than one cylinder is misfiring, the misfire current counters may only increment for one cylinder. Example: Cylinders 1 and 8 are both misfiring, yet only cylinder 8 increments on the misfire current counter.

   If one of the injector fuses is open, only two or three misfire current counters may increment for the corresponding side of the engine.

2. 4
   
   The cylinder with the more significant misfire may cause another cylinder counter to increment only by a small amount.
3. 10
   
   If the engine misfire moves with the spark plug, this is good indication that you should replace the spark plug.
4. 12
   
   An engine mechanical problem can cause a spark plug to gas foul. Inspect for loose rockers, collapsed lifters, or worn camshaft lobes.
5. 17
   
   If the customer concern is the MIL flashing, this indicates that a Catalyst Misfire has occurred. Drive the vehicle in the conditions to run the catalyst diagnostic.