LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 727 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Roof Weld Joint Reveal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Heat the weld join molding, using a heat gun J 25070  152 mm (6 in) from the surface.

    Apply the heat using a circular motion for about 30 seconds.

    NOTE: Refer to Exterior Trim Emblem Removal Notice in Cautions and Notices.
  2. To remove the weld joint molding from the roof, begin at one end and use a small plastic flat-bladed tool. Lift the weld joint molding away from the weld joint.
    Fig 1: Removing Roof Weld Joint Reveal Molding
    G01503830Courtesy of GENERAL MOTORS CORP.
  3. Remove all adhesive from the body panel using 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
  4. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.
    Fig 2: Removing Adhesive From Body Panel
    G01503831Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals