Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Apply the emblem/nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.

Clean the area where the emblem/nameplate will be installed.
Use a lint free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol and water to clean the area.
Dry the area thoroughly.
If the location of the GTP emblem/nameplate has not been marked, apply tape and mark the location as shown.

Fig 1: Identifying Location For Installing GTP Emblem On Door
Courtesy of GENERAL MOTORS CORP.
For the GRAND PRIX SE emblem/nameplate install as shown in Fig 2.

Fig 2: Identifying Location For Installing GRAND PRIX SE Emblem On Door
Courtesy of GENERAL MOTORS CORP.
For the GRAND PRIX GT emblem/nameplate install to the following dimensions:
- Dimension (A) is 70 mm (2.750 in) from the top of the lower door molding to the bottom of the emblem/nameplate.
- Dimension (B) is 89 mm (3.500 in) from the front door edge to the front of the emblem/nameplate.
Heat the mounting surface to approximately 27-41°C (80-105°F) using the J 25070 , if necessary.
Ensure that the temperature of the emblem/nameplate is approximately 29-32°C (85-90°F).

Fig 3: Identifying Location For Installing GRAND PRIX GT Emblem On Door
Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not touch the adhesive backing on the emblem/nameplate.
Remove the protective liner from the back of the emblem/nameplate.
Position the emblem/nameplate to the location marks and press the emblem/nameplate to the mounting surface.
Apply equal pressure along the emblem/nameplate in order to uniformly bond the item to the mounting surface.
Remove the protective tape from the mounting surface.