LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 721 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Cupholder Replacement - Front Floor Console >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front floor console trim plate. Refer to TRIM PLATE REPLACEMENT - FRONT FLOOR CONSOLE  .
  2. Remove the support springs from the console cup holder.
    Fig 1: Removing Support Springs From Console Cup Holder
    G01503672Courtesy of GENERAL MOTORS CORP.
  3. Insert a flat-bladed tool under the hinge pivot point and pull the cupholder forward.

    Repeat for the opposite side.

    Fig 2: Inserting Flat-Bladed Tool Under Hinge Pivot Point
    G01503673Courtesy of GENERAL MOTORS CORP.
  4. Remove the cupholder from the console trim plate.
    Fig 3: Removing Cupholder From Console Trim Plate
    G01503674Courtesy of GENERAL MOTORS CORP.
  5. Remove the support springs from the cupholder.
    Fig 4: Removing Support Springs From Cupholder
    G01503675Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals