LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 716 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Cupholder Replacement - Front Floor Console >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front floor console trim plate. Refer to TRIM PLATE REPLACEMENT - Front Floor Console .
  2. Remove the support springs from the console cup holder.
    Fig 1: Removing Support Springs
    G01616575Courtesy of GENERAL MOTORS CORP.
  3. Insert a flat-bladed tool under the hinge pivot point and pull the cupholder forward.

    Repeat for the opposite side.

    Fig 2: Pulling Cupholder Forward
    G01616576Courtesy of GENERAL MOTORS CORP.
  4. Remove the cupholder from the console trim plate.
    Fig 3: Removing Cupholder From Console Trim Plate
    G01616577Courtesy of GENERAL MOTORS CORP.
  5. Remove the support springs from the cupholder.
    Fig 4: Removing Support Springs From Cupholder
    G01616578Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals