LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 709 (Engine Mechanical - 3.8L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Fuel Injector Sight Shield Replacement (L36) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the area around the tube/oil fill cap before removing the tube/oil fill cap in order to prevent contaminants from falling into the valve rocker arm cover opening.
  2. Twist counterclockwise to unlock the tube/oil fill cap from the valve rocker arm cover.
  3. Lift the fuel injector sight shield up at the front and slide the tab out of the engine bracket.
  4. Replace the tube/oil fill cap in the valve rocker arm cover.
    Fig 1: Removing Valve Rocker Arm Cover And Oil Fill Cap (L36)
    G02083416Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals