LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 709 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the oil level indicator tube.
    • Lubricate the O-ring with engine oil and make sure it is in place.
    • Make sure the assembly is fully seated in the engine block.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the oil level indicator tube nut.

    Tighten 

    Tighten the nut to 19 N.m (14 lb ft).

  3. Install the oil level indicator.
    Fig 1: Installing Oil Level Indicator Tube
    G02083953Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals