LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 709 (Engine Mechanical - 3.8L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Crankshaft Balancer Installation >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the seal surface of the crankshaft balancer with engine oil.
  2. Install the crankshaft balancer.
  3. Use J 37096  to hold the flywheel.
    Fig 1: Installing Flywheel Holder To Hold Flywheel
    G02083959Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to SPECIAL FASTENER NOTICE in Cautions and Notices.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the crankshaft balancer bolt.

    Tighten 

    Tighten the crankshaft balancer bolt to 150 N.m (111 lb ft). Use J 36660-A  to tighten the crankshaft balancer bolt an additional 76 degrees.

    Fig 2: Installing Crankshaft Balancer
    G02083960Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals