LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Engine Mechanical - 3.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Balancer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The inertial weight section of the crankshaft balancer is assembled to the hub with a rubber type material. The correct installation procedures (with the proper tool) must be followed or movement of the inertial weight section of the hub will destroy the tuning of the crankshaft balancer.
  1. Remove the drive belt. Refer to DRIVE BELT REPLACEMENT  .
    Fig 1: Removing Crankshaft Balancer Bolt
    G02081427Courtesy of GENERAL MOTORS CORP.
  2. Raise and support the vehicle. Refer to JACKING AND LIFTING in General Information.
  3. Remove the right front tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  4. Remove the right engine splash shield. Refer to SPLASH SHIELD REPLACEMENT - ENGINE in Body Front End.
  5. Install the jack stands to the frame.
  6. Loosen the left frame bolts and remove the right side frame bolts.
  7. Using the jack stands, lower the right side of the frame to access the crankshaft balancer.
  8. Remove the torque converter covers.
  9. Install the J 37096  to the flywheel to prevent flywheel rotation.
  10. Remove the crankshaft balancer bolt and the washer.
  11. Remove the crankshaft balancer. Use the J 24420-C  .
    Fig 2: Removing Crankshaft Balancer
    G02081428Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals